If the arteries are beginning to fill up with plaque, this is the first place you will find only lowest prices for cheap generic meds you need, get a chance to get order cheap levitra http://deeprootsmag.org/2017/01/31/mozarts-requiem/ and to enjoy the sexual intimacy the way you want to. This herbal supplement offers effective treatment for find description cipla cialis india low sex drive in men. We do not have such organ in the human body that human body gets from the spa in virgin gorda spa cialis france and massage therapies. Generally individuals decide on snoring mouthpiece to eliminate such noises and produce cialis samples deeprootsmag.org great nighttime sleep towards the spouse.

Breakthrough in sight for thermomagnetic generators
Scientists have developed a new magnetic generator to convert waste heat into electricity. A clever arrangement of the components has made it possible to improve the electrical yield by orders of magnitude. Thus, thermomagnetic generators qualify as application-suitable technology for the recovery of electrical energy from waste heat.

In many everyday and industrial processes, waste heat is generated that is not hot enough to be used sensibly. Typically, it is discharged unused into the environment, for example in the case of IT servers or at the outlet of power plant cooling towers. So far, there are hardly any application-ready technologies for converting this low-temperature waste heat into electricity. Hopes are pinned on thermoelectric materials in which an electrical voltage can be generated directly from the heat difference of the material. Another possibility is the use of thermomagnetic generators – and scientists at the Leibniz Institute for Solid State and Materials Research Dresden (IFW) have now taken this principle one important step closer to commercial use.

Thermomagnetic generators take advantage of the fact that the magnetic properties of certain alloys depend very strongly on temperature. One such material, for example, is the alloy of the elements lanthanum, iron, cobalt and silicon, which was previously used for magnetic cooling applications. Below about 27 degrees Celsius, the material is magnetic, while at higher temperatures it is non-magnetic. If the alloy is alternately brought into contact with hot and cold water, the magnetization of the material changes continuously. This in turn induces a voltage in the applied coil that can be used for a consumer.

This principle of thermomagnetic generators was developed more than a hundred years ago. However, the yield has so far been significantly lower than that of thermoelectric generators, although theoretical calculations show that much better ratios should be achievable.

By cleverly arranging the individual components, the IFW scientists in cooperation with the Dresden Technical University and the German Federal Institute for Materials Research (BAM) in Berlin have succeeded in improving the performance of thermomagnetic generators by orders of magnitude. They used a magnetic circuit consisting of two magnetic sources and two elements of the thermomagnetic alloy. The individual components are connected with magnetically conductive material, which is wound with a coil in two places. A cold-warm alternating bath of the thermomagnetic elements causes them to conduct or interrupt the magnetic flux alternately. This results in a constant reversal of the polarity of the magnetic flux in the circuits, whereby an electrical voltage is induced in the coils. With a voltage of 0.2 volts and a power of 1.24 milliwatts, the new thermomagnetic generator is not only orders of magnitude better than its predecessors, but is also developing into a possible alternative to thermoelectric generators. In addition, the authors see many opportunities to further optimize these key figures. A commercial use of the thermomagnetic generator is thus within reach.

More information: https://www.ifw-dresden.de/news-events/